1/8" Cable Stair Assembly (QC Lag Pivot & 7-1/2” Terminal for wood posts)
1 qty: 1/4"-20RH Snug-Grip® washer nut
1 qty: 3/4”OD x 9/32”ID Beveled Washer
1 qty: 1”OD x 3/8”ID Flat Washer
1 qty: 20-ft length of 1/8” diameter cable with Threaded Terminal fitting pre-attached to one end
1 qty: Quick-Connect® Pivot

Product Specifications
Type	7-1/2" Terminal (Wood Post)
Length	20 ft
Diameter	1/8"
Package Size	Each
Material Type	316 grade stainless steel
Included Accessories	(1) selected length of 1/8" cable with pre-attached Threaded Terminal fitting, (1) Quick-Connect® SS fitting, (2) stainless steel Flat Washers and (1) stainless steel Snug-Grip® washer nut
Warranty	CableRail 10 Year_ Limited Warranty

To minimize cable deflection, each cable, when properly installed, will have a tension load of at least 300 lbs. Therefore, it's important that frames are designed and built strong enough to support these loads. Review Frame Requirement Detail to help you prepare the railing for cable infill.

We strongly advise against exceeding a 3-inch cable spacing.

We recommend having a post or vertical member (intermediate picket) at least every 3 feet.

Standard Cable Assembly don't require special crimpers or tensioning tools. The basic tool list would include: Electric drill and bits, ViseGrip® pliers, 7/16" wrench for tightening washer nuts and a cut-off disk for trimming ends.

Give us a call if you need assistance, 707-224-9100